Home > Hp Psc > Hp Psc 1610 Paper Jam Error Message

Hp Psc 1610 Paper Jam Error Message

Don't force anything, though. 8 Replace the toner or ink cartridge and paper trays, close any doors you opened and turn the printer back on. 9 If the printer paper jam Only add paper to the tray when the product is not printing. Figure : Open the cartridge access door Disconnect the power cord from the back of the product. The following symptoms might also occur: The product will not print. Check This Out

There is no jam, what can I do? the printer picks upthe paper, but doesn't print, sends it about half way through the print cycle then stops with a paper jam error. Align the door pins with the slots on the right side of the rear of the product, and then push the door forward, snapping it into place. Let glue fully set before turnig over by hand first, cleaning off excess araldite, than under power.Total repair time approx 3 hours so only bother if you really love that printer! http://support.hp.com/us-en/document/c00212225

Only add paper to the tray when the product is not printing. Unplug the power cord from the back of the product. Z7_M0I02JG0KONJ30ACBBF8MM1084 hp-hero-support-search Actions ${title} Loading... Do not pull jammed paper from under the front cover Step two: Clear the paper jam from the rear of the All-in-One Use the following steps to clear the paper jam

caution: Do not remove jammed paper at this stage. Z7_3054ICK0KGTE30AQO5O3KA30N0 hp-concentra-wrapper-portlet Actions ${title} Loading... Press the Power button () to turn on the product. See the section on how to use these solutions at the beginning of this document.

Figure : Close the cartridge access door Reconnect the power cord to the back of the product. Please upload a file larger than 100x100 pixels We are experiencing some problems, please try again. Press the On button () again to turn the product on. by electrostupid33 on Jun 21, 2013 at 3:51pm Add comment Please sign in to comment 0 My HP PSC 1610 printer shows a "Scanner Failure, turn printer off and on again"

If the self-test report does not print, skip to the next solution. When I close the lid the cartridges move but there is a distinct three clicks almost like it is breaking and then nothing. The paper doesn't budge. However, now while the printer is at home it doesn't want to work.

Step six: Make sure the control-panel faceplate is correctly installed If the front panel faceplate (overlay) is already installed, and your product has been working for some time, do not attempt http://support.hp.com/us-en/document/c01577197 Step three: Clear the jam from the front of the All-in-One Follow these steps to remove the paper jam from the front of the product. Plug the power cord back into the wall outlet. by unknown on Jan 15, 2009 at 5:28pm Add comment Please sign in to comment 0 Where to find the 40mm gear.It's a while since I checked this email so I

Thank you! Register · Log In HP Support Forum Home > Printers > LaserJet > PSC 1610 After paper jam HP Support Forums Join in the conversation. his comment is here Read more Mark as irrelevant Marked as irrelevant Undo Other solutions How do you fix the paper jam notification on my hp psc 1350? When you have resolved the issue, and the product successfully prints a self-test report, there is no need to continue troubleshooting. The opposite side would be the rear.

Please help. Move the carriage all the way to the left with your hand. After the page prints, alignment is complete. http://permamatrix.net/hp-psc/hp-psc-1610-error-411.html by csk on Jul 9, 2010 at 1:08pm Add comment Please sign in to comment 0 I agree; I did the same and the roller only rolls one way; there are

If you continue to receive a printer jam error try repeating the above steps again. Z7_3054ICK0KGTE30AQO5O3KA3015 hp-online-communities-portlet Actions ${title} Loading... The power cord must be unplugged to allow the parts to be moved by hand and to reset the paper feed mechanism, without the risk of an electrical shock.

I was having the same problem with my HP C3180 and I did what you said.

If the carriage is stuck on the right side, move the carriage to the left side of the product. The tray is too full. I have checked and there is no paper in the rollers. Step three: Make sure that the print carriage can move freely Follow these instructions to make sure the print carriage can move freely.

Support Forum Join the conversation! by Anonymous on Mar 30, 2009 at 9:13pm Add comment Please sign in to comment 0 I am having the same problem with the "Out of Paper" message. Paper was added to a stack already in the tray while the HP product was printing. navigate here Step nine: Print a self-test page Follow these instructions to print a self-test page.

Reconnect the USB cable, and then try to print again. Reconnect the power cord to the back of the product, and then press the Power button () to turn on the product. Turn the product on, if necessary. by Anonymous on Jan 15, 2009 at 4:58pm Add comment Please sign in to comment 0 Remove the rear cleanout door and clean the four small rollers at the top and

Privacy Policy © Copyright 2016 HP Development Company, L.P. I have removed and re-installed the cartridges several times.